Lap Fence Panels | Treated Brown Timber

Our lap fence panels are manufactured on site here in our Longwick workshop by our own panel makers. The slats run horizontally and are nailed in place with fencing batten front and rear, then sandwiched along the top and sides. The panel is then finished on top with a capping rail allowing water run off.  So that it withstands the elements, the fence panel is then dipped in a treatment tank. The Slat along the bottom horizontal edge of the panel is a piece of feather edge, which is much thicker than a panel slat. This adds much more strength to the bottom edge of the panel. 

Often referred to as a standard panel, the brown treated lap panels continue to be our best selling fence panel. 

 The back of our panels are braced with vertical battens nailed firmly into position. 

Lap panels are an economical solution to fencing your property. If you are left with an odd size gap at the end of the run of fencing then our workshop has the ability to make a bespoke size panel to your size requirements (maximum 1.83m x 1.83m). 

Which fence posts should I use for lap fence panels?

Our lap fence panels are suitable for use with timber and slotted concrete fence posts. 75mm x 75mm fence posts are adequate for fences in sheltered locations. In areas susceptible to wind, heavy traffic we recommend posts with a minimum width of 100mm x 100mm (4"x 4") . If the fence is being installed in an area with a likiehood of damp conditions or water logging then our Redwood UC4 posts are very highly recommended. See our BLOG entry on the benefits of using UC4 posts for more information. 

Collection OR Delivery

Delivery service available within 20 miles of our premises. No minimum order. FREE delivery to Princes Risborough, Haddenham, Thame, Chinnor & more.